Home > news
Source : exam4testClick : 522
 
Date:2009-11-13 10:44

642-746 practice exam

642-746 Exam Description

IUWMS (642-746)
Implementing Cisco Unified Wireless Mobility Services
Exam Number: 642-746
Associated Certifications: CCNP Wireless
Duration: 90 minutes (50-60 questions)
Available Languages: English
Register for Exam:
Pearson VUE
Exam Policies: Read current policies and requirements
Exam Tutorial: Review type of exam questions
Register for Course: IUWMS courses and other offerings

642-746 Exam Topics

The following information provides general guidelines for the content likely to be included on the exam.

 However, other related topics may also appear on any specific delivery of the exam. In order to better 

reflect the contents of the exam and for clarity purposes the guidelines below may change at any time 

without notice.
642-746 IUWMS Exam Topics

Recommended Training
The following course is the recommended training for this exam:
Implementing Cisco Unified Wireless Mobility Services (IUWMS)

Courses listed are offered by Cisco Learning Partners the authorized source for Cisco IT training 

delivered exclusively by Certified Cisco Instructors. For a list of Cisco Learning Partners, use the 

Learning Partner Locator.
Additional Resources
A variety of Cisco Press titles may be available for this exam. These titles can be purchased through

 the Cisco Marketplace Bookstore, directly from Cisco Press.

Donwload Free exam4test Braindumps The Most Realistic Practice Questions and Answers,Help You

 Pass any Exams

latest 642-746 practice exam

80. You have oversubscribed your redundant controller and two controllers on the same power source have failed. The first floor has just recently been deployed and you have not changed the default configuration of the access point priority. What default failover priority do these new access points have using Cisco WLC version 5.2?
Select the best response.
A. no priority
B. low priority
C. medium priority
D. high priority
E. critical priority
Answer: A

81. You are configuring the Client Roaming behavior of the Cisco WLC and you are looking to changethe RF Parameters to improve roaming. The Transition Time option changes which characteristic of the Cisco Compatible Extensions Client Roaming behavior?
Select the best response.
A. the maximum time it should take for a client to respond to an eligible AP neighbor list
B. the maximum time it should take for a client to roam to and complete an AP to AP roam
C. the maximum time it should take for an AP to respond to a neighbor query
D. the minimum time it should take for an AP to provide a neighbor list
Answer: B

82. You are configuring controller redundancy and are about to adjust the fast heartbeat timer. What does an AP do when the configured heartbeat timer interval expires?
Select the best response.
A. Sends data channel controller packets, if it does not get a response it does a fast failover to the secondary controller.
B. Sends an MPING to both its secondary and primary controller, then it does a fast join to whichever responds first.
C. Checks to see if it has received any control packets from the controller; if not, it then sends a fast echo request to its configured secondary controller.
D. Checks to see if it has received any data packets from the controller; if not, it sends a fast echo request to its configured primary controller.
Answer: D

83. When configuring secondary or tertiary controllers that are not part of the primary controller mobility group, what information is required?
Select the best response.
A. AP manager interface
B. manager interface
C. management IP address
D. mobility group
E. AP manager IP address
Answer: C

84. When configuring a primary, secondary, or tertiary controller on an access point, which IP address do you provide?
Select the best response.
A. AP manager interface
B. management interface
C. mobility manager interface
D. mobility group interface
E. virtual manager interface
Answer: B

85. On your campus, you have a controller in each building and they are close enough that users can roam seamlessly between them. You have received several complaints that users in your main building are experiencing one-way audio problems when they walk into the central building. What is the cause of this issue?
Select the best response.
A. The client IP address is not in the routing table of the central building.
B. The main building controller is blocking RTP packets inbound.
C. A firewall is denying packets in one direction based on the source address.
D. A firewall is blocking controller-to-controller traffic.
Answer: C

86. Refer to the exhibit. You have been tasked with deploying your company’s wireless LWAPP deployment within an area that must have the best possible availability you can provide. Although a supported design, which disadvantage does the shown solution have?
942704995.jpg
Select the best response.
A. a single point of failure at the IDF switch
B. no client load-balancing
C. frequent inter-controller roaming
D. cannot support Voice over WiFi deployments
Answer: C

87. Refer to the exhibit. You have decided to use the individual ports in trunking on your Cisco 4402-50 controller. You have placed one port on each separate switch as shown and you have fully loaded 50 access points on this controller, placing 25 APs on each physical port and associated AP manager interface. During a power outage, you have lost one of these switches. Your access layer is unaffected and all 50 access points still have power and attempt to move to the other physical port and rejoin the AP manager interface that remains up. How many access points will be able to connect to this controller?
Select the best response.
1646207842.jpg
A. All 50 APs will connect.
B. All APs will try to rejoin the controller no matter what interface goes down.
C. Each port can only support 48 APs and therefore 2 APs will not be able to join.
D. Only 25 APs will remain joined and the other APs will look for another controller.
Answer: C

88. You are working in a global company. You have been tasked to configure two redundant controllers that are not specific for any one country. How many countries can you select per controller with the country feature using Cisco WLC version 5.2?
Select the best response.
A. 5
B. 10
C. 14
D. 20
Answer: D

89. You have configured multiple country codes on your controller. You are using the Cisco WLC GUI to set the individual APs to the appropriate country code. How will this effect any associated clients on a changed AP?
Select the best response.
A. This is a minor change and no associations will be lost.
B. The AP must be disabled so all clients will be disassociated.
C. The clients will drop but immediately reassociate.
D. The clients will remain associated until you click Apply and the AP will then reboot.
Answer: B

90. You have configured Symmetric Mobility with AES for mobility data encryption. Which UDP port does this mobility exchange use?
Select the best response.
A. 1701
B. 16443
C. 16666
D. 16667
Answer: D

 

Other News

 


Guarantee | How Order | F.A.Q. | Payment | Refundment Term | Samples | privacy | Guarantee | Sitemap 1 2 3 4
CCNA | CCNP | CCIE | CompTIA A+ | CompTIA Security+ | CompTIA Network+ | CompTIA Linux+ | CompTIA Project+ | IBM certifications I | Oracle 11i | IBM DB2 | SCJP | JNCIA

Copyright©2006-2009 Exam4test Limited. All Rights Reserved RSS

links:Testinside   Testinside    Examsoon   the latest video converter soft.